So I was having trouble with a system build (software) and I set off a Macrium Reflect system image restore. When I came back to the laptop it was stuck in a permanent loop were it says Restarting on the windows light blue screen, then the screen goes blank for a couple of minutes and back to the same system restarting message and black again.
I got into the Insyde H2O BIOS looking to find a way to set the boot priority or system restore section but I am finding it to be very unintuitive.
I have the boot drive I got with my laptop plugged into the machine but I can't see a way to get the machine to boot from this drive.
I have attached a screen shot of the Boot From File explorer page but it is not obvious to me what to do next.
It looks like it is just showing me local files and not files from the usb boot drive.
Any help would be appreciated.
Thanks
Colin
Recoil 17" laptop
Windows 10
i7-11700K
RTX 3080
64Gb 2667Mhz
I got into the Insyde H2O BIOS looking to find a way to set the boot priority or system restore section but I am finding it to be very unintuitive.
I have the boot drive I got with my laptop plugged into the machine but I can't see a way to get the machine to boot from this drive.
I have attached a screen shot of the Boot From File explorer page but it is not obvious to me what to do next.
It looks like it is just showing me local files and not files from the usb boot drive.
Any help would be appreciated.
Thanks
Colin
Recoil 17" laptop
Windows 10
i7-11700K
RTX 3080
64Gb 2667Mhz